Disclaimer: All tool outputs are preliminary engineering estimates for reference only. All design parameters must be verified with official datasheets and the ODMLCD engineering team before prototype and mass production. This tool shall not be liable for any direct or indirect design decisions based on estimated results.

TFT LCD Module Spec Comparator

Shortlisting two or three candidates? Pick them below and see every key spec side by side — differences are highlighted so the trade-offs are obvious at a glance. Data comes from our live standard catalog.

Select two modules and press Compare.
Data from our current catalog — the module datasheet remains authoritative.

FAQ

Where does the comparison data come from?

From the same catalog that powers our Display Finder, reflecting the modules currently available at RONEN. The module datasheet always remains the authoritative source for design.

Can I compare a RONEN module against a competitor part?

This tool compares our standard modules with each other. If you have a competitor or legacy part number, use the LCD Replacement Finder — it maps legacy panel numbers to our published replacements.

What do the highlighted cells mean?

Highlighted cells mark specs that differ between the two modules, so you can spot the trade-offs — brightness, interface or temperature range — without reading every row.

Want these numbers against a real module?
Send your timing, brightness or environment requirements — an application engineer replies once the project scope is confirmed with matching standard models and a quote.
Talk to RONEN →
Engineering Tool Disclaimer

All embedded tools on this page provide preliminary technical estimates only. No calculated result shall be regarded as an official specification, design standard or production basis. All display-related design, circuit, installation and production parameters must be confirmed by ODMLCD official datasheets and professional engineering staff. ODMLCD is not responsible for any design, modification, production decision or loss caused by tool reference data.