TM070JDHG34 Alternative Source — Engineering Cross-Reference

2026-11-12 · RONEN Display Engineering
Looking for verified specifications or an engineering reference for TM070JDHG34? This page documents the published Tianma module parameters and the RONEN engineering review route. This page does not assert that a verified drop-in replacement exists.

TM070JDHG34 published parameters — engineering reference

The table documents the published module parameters. Any RONEN module of the same size and resolution is shown for engineering reference only, not as a verified replacement. Fields that depend on the original manufacturer's datasheet are referred to that document rather than restated as a value we have not issued.

Verification status: A 100%-compatible, drop-in replacement has not been verified for this part number. The specification table below documents the original module parameters for engineering reference only. Interface, connector pin assignment, mechanical outline, backlight drive and timing must be confirmed by RONEN engineering against your existing design before any module is proposed.

ParameterTianma standard moduleRONEN engineering reference (not verified)
Part numberTM070JDHG34No verified replacement (see status above)
Display size7 inch7.0 inch
Resolution1280x8001280x800
Luminance500cd/㎡400 cd/m²
Operating temperature-20~70℃-20 ~ 70
InterfaceLVDS (1 ch, 6/8-bit), 20 pinsLVDS 40 Pin
Active area149.76 × 93.6 mm149.76x93.60
Outline161 × 107 × 4.1 mm161.0x107.0x3.35
Panel modeOriginal specificationIPS
Driver ICNot disclosed by manufacturer3*ST5821C and 1*ST5084C
TouchOriginal specification; touch is a project option on the RONEN sideWithout touch / capacitive or resistive available per project

Engineering checks before considering RG-T070TISA-01

For a 7″ 1280x800 module, the evaluation covers the active area, interface family, luminance, panel mode and mechanical outline. Connector pin assignment, backlight drive conditions and timing are reviewed against your existing design by RONEN engineering. Capacitive or resistive touch can be specified as part of the ODM/OEM build.

Other Tianma part numbers mapped to this size class are listed in the Tianma cross-reference index, or use the alternative source finder to search by part number.

Request an engineering fit review

Send the original part number TM070JDHG34, your interface requirement and the target mechanical envelope. RONEN engineering reviews the electrical and mechanical fit per project and confirms whether a usable module exists before any order is placed.

Contact RONEN engineering → · Reference RG-T070TISA-01 specifications (reference only) →

This is a documented engineering cross-reference. Interchangeability is not asserted, and no 100%-compatible replacement has been verified for this part number. Any module proposal requires per-project engineering review.

How these numbers are measured

These are generic test-method standards cited to explain how each specification is defined and measured. They are not product certifications. The actual test conditions and rated values for each RONEN model are stated in that model's datasheet.