G043FW01-V0 Alternative Source — Engineering Cross-Reference

2026-11-12 · RONEN Display Engineering
Looking for verified specifications or an engineering reference for G043FW01-V0? This page documents the published AU Optronics (AUO) module parameters and the RONEN engineering review route. This page does not assert that a verified drop-in replacement exists.

G043FW01-V0 published parameters — engineering reference

The table documents the published module parameters. Any RONEN module of the same size and resolution is shown for engineering reference only, not as a verified replacement. Fields that depend on the original manufacturer's datasheet are referred to that document rather than restated as a value we have not issued.

Verification status: A 100%-compatible, drop-in replacement has not been verified for this part number. The specification table below documents the original module parameters for engineering reference only. Interface, connector pin assignment, mechanical outline, backlight drive and timing must be confirmed by RONEN engineering against your existing design before any module is proposed.

ParameterAU Optronics (AUO) standard moduleRONEN engineering reference (not verified)
Part numberG043FW01-V0No verified replacement (see status above)
Display size4.3 inch4.3 inch
Resolution480x272480x272
Luminance450cd/㎡300 cd/m²
Operating temperature-20-70(℃)-20 ~ 70
InterfaceParallel RGB (TTL), 45 pins, 8-bitRGB 24bit 40PIN
Active area95.04 × 53.856 mm95.04x53.86
Outline105.7 × 67.4 × 4.19 mm105.50x67.15x3.05
Panel modeOriginal specificationTN
Driver ICNot disclosed by manufacturerILI6485
TouchOriginal specification; touch is a project option on the RONEN sideWithout touch / capacitive or resistive available per project

Engineering checks before considering RG-T043BPI-01ND

For a 4.3″ 480x272 module, the evaluation covers the active area, interface family, luminance, panel mode and mechanical outline. Connector pin assignment, backlight drive conditions and timing are reviewed against your existing design by RONEN engineering. Capacitive or resistive touch can be specified as part of the ODM/OEM build.

Other AU Optronics (AUO) part numbers mapped to this size class are listed in the AU Optronics (AUO) cross-reference index, or use the alternative source finder to search by part number.

Request an engineering fit review

Send the original part number G043FW01-V0, your interface requirement and the target mechanical envelope. RONEN engineering reviews the electrical and mechanical fit per project and confirms whether a usable module exists before any order is placed.

Contact RONEN engineering → · Reference RG-T043BPI-01ND specifications (reference only) →

This is a documented engineering cross-reference. Interchangeability is not asserted, and no 100%-compatible replacement has been verified for this part number. Any module proposal requires per-project engineering review.

How these numbers are measured

These are generic test-method standards cited to explain how each specification is defined and measured. They are not product certifications. The actual test conditions and rated values for each RONEN model are stated in that model's datasheet.