ET104S0M-N10 Alternative Source — Engineering Cross-Reference
Looking for verified specifications or an engineering reference for ET104S0M-N10? This page documents
the published BOE Technology (BOE) module parameters and the RONEN engineering review route. This page does not assert that a verified drop-in replacement exists.
ET104S0M-N10 published parameters — engineering reference
The table documents the published module parameters. Any RONEN module of the same size and resolution is shown for engineering reference only, not as a verified replacement. Fields that depend on the original manufacturer's datasheet are referred to that document rather than restated as a value we have not issued.
Verification status: A 100%-compatible, drop-in replacement has not been verified for this part number. The specification table below documents the original module parameters for engineering reference only. Interface, connector pin assignment, mechanical outline, backlight drive and timing must be confirmed by RONEN engineering against your existing design before any module is proposed.
| Parameter | BOE Technology (BOE) standard module | RONEN engineering reference (not verified) |
|---|---|---|
| Part number | ET104S0M-N10 | No verified replacement (see status above) |
| Display size | 10.4 inch | 10.4 inch |
| Resolution | 800x600 | 800x600 |
| Luminance | 350cd/m2 | 350 cd/m² |
| Operating temperature | -20~70°C | -20 ~ 70 |
| Interface | LVDS (1 ch, 6/8-bit), 20 pins Connector | LVDS 8bit 20PIN |
| Active area | 211.2 × 158.4 mm | 211.20x158.40 |
| Outline | 236 × 176.9 × 5.9 mm | 236.00x176.90x5.60 |
| Panel mode | Original specification | TN |
| Driver IC | Not disclosed by manufacturer | |
| Touch | Original specification; touch is a project option on the RONEN side | Without touch / capacitive or resistive available per project |
Engineering checks before considering RG-T104QGH-01
For a 10.4″ 800x600 module, the evaluation covers the active area, interface family, luminance, panel mode and mechanical outline. Connector pin assignment, backlight drive conditions and timing are reviewed against your existing design by RONEN engineering. Capacitive or resistive touch can be specified as part of the ODM/OEM build.
Other BOE Technology (BOE) part numbers mapped to this size class are listed in the BOE Technology (BOE) cross-reference index, or use the alternative source finder to search by part number.
Request an engineering fit review
Send the original part number ET104S0M-N10, your interface requirement and the target mechanical envelope. RONEN engineering reviews the electrical and mechanical fit per project and confirms whether a usable module exists before any order is placed.
Contact RONEN engineering → · Reference RG-T104QGH-01 specifications (reference only) →
This is a documented engineering cross-reference. Interchangeability is not asserted, and no 100%-compatible replacement has been verified for this part number. Any module proposal requires per-project engineering review.